I just had a look at your project - looks fine to me. So I guess it was the post-processing: You need to switch to the last time step and then rescale the color bar to see the von mises gradient properly.
Hi Simscale, even though the simulation was finished, I didn´t get “Convergence plots” in the menu of simulation runs.
… and also menu on the left didn´t show the “Solution fields” in the Post Processor .
Should I delete it and start again this simulation (I did it twice)? Besides, I had an error which was reported before. I have been trying to finish these simulations since the last days without any results. It took so much time waiting for the simulation, I had to log out. Sorry, but the connection here is not so good and very slow with interruptions as well.
make sure you share your project link if you have problems so that the support does not need to ask for it in a seperate post/answer therefore an occurrence of delay in solving your problem(s).
Also make sure you have just one workbench open at a time to prevent problems.
As you can see for me it works perfectly fine. If I did not get you please give an explanation.
Some quick tips:
• As mentioned before only one workbench at a time opened
• Clear cookies of your browser
• Sometimes refreshing the page or reopening of the project helps